This is the 3rd pump thats done this and it's not very old
Check the top connection all tight and on the inflate side
Pull top off check piston and valves all look ok
But still no air coming out the end, anyone know where my air is going??
Have you tried pulling the handle up and down? sometimes when mine isn't working this is the problem...
Perhaps its cos of the low air pressure...
That's happened to me before, a massive low pressure system meant my pump couldn't convert the air into high pressure to pump up my kite... Just had to watch that day.
Make sure the check valves work, pump should have some resistance whilst pumping.
If there is resistance undo the piston from the shaft and check the pipe that runs up the shaft to the handle, if this is kinked you won't get air out.
I would expect air to be bypassing somewhere on this one though.
Unscrew the pump clean the inside out with a rag and the o ring at the bottom of the handle then re grease the o ring and inside of the shaft works really well like a new pump . Other than that check for a crack in the pump when your kite gets to the right pressure the air starts coming out the crack and your kite just won't seem to pump up any more.
Don't use any grease petroleum jelly etc use silicon spray to lube the piston valves etc
Thanks for this info....I just pulled two pumps apart to find them full of sand and one had water in it as well. Now they both work again. Sweet....
The new Cabrinha pumps (apparently made in Italy) are totally awesome. I was testing out their new kites at the time and decided to only buy the pump. The pump is leagues ahead of all the other rubbish out there. At $30 a blessing when it makes pumping almost a pleasure.
