Had to do some repairs on my mates quad on the weekend. Its a DHD 6,4 diamond tail.
The fin set up is a bit different to my Bourton, so I took some pics to show the difference.
On the DHD the rear fins are close together but on the Burton the rear fins are spread more apart.
The DHD used to be my board
Doggie that would be a worry but all reports tell me there looking for a Aussie Doggie for a bit of stud work so you best head off to NZ.
6.4 oh your talking board length,I was thinking 6.4 inch fins
So doggie you've ridden both whats the go.
I'm in Sydney, and I don't have my Quads close by to throw up some actuall measurements...
Doggie, the following measurements could be good...
Rear of rear fin from tail
Rear of front fin from tail
Board width at 1 foot from tail
Board width at rear of rear fin
Board width at rear of front fin
Rear of rear fin, offset from stringer
Rear of front fin, offset from stringer
Might all be a bit too hard !! ....
Half true Mac only 1 comp so far this year results not for publication,someone has to make up the numbers actually i support longboarding so i enter a few comps to keep them going afterall if no one supported the events longboarding would dissappear.Remember thats where it all started pretty much.Happy Surfing.
Got enough kooks over here now