I am sure your original starter motor would be completely repairable. Get a new one that fits to get you out of trouble, get the old one rebuilt then fit it back in and keep the new one in a sealed bag as a spare.
I am sure your original starter motor would be completely repairable. Get a new one that fits to get you out of trouble, get the old one rebuilt then fit it back in and keep the new one in a sealed bag as a spare.
Even after my trusted mechanic for 10 years tells be the starter cannot get rebuilt due to discontinued parts?
I am sure your original starter motor would be completely repairable. Get a new one that fits to get you out of trouble, get the old one rebuilt then fit it back in and keep the new one in a sealed bag as a spare.
Even after my trusted mechanic for 10 years tells be the starter cannot get rebuilt due to discontinued parts?
Well then you are ed.
100% ! Solenoid is engaging fine, the gear is spinning on the shaft when engaged with flywheel basically it's a blown gear box inside the starter. 1987 lucus marine starter and the replacement will be around $850 according to ebay prices
Lucus Prince of darkness in my trade its called
Never wash a early model Land rover engine Unless you don't need to go any where for a few hours
I have a penchant fro British sportscars so Lucas, the Prince of Darkness is always lurking. But, their stuff can nearly always be rebuilt, like the cars themselves. They aren't throw away so a rebuild is very likely to be possible. A new drive will probably be a lot cheaper, but will take time to get.
It is a beautiful piece of British engineering would be a shame to have to bin it. I will look into rebuilding it tomorrow after I fit the copy and get my girl back to her berth!
Clean the armature segments after a clean up with some emery tape .
I used to use a hack saw blade ground down sort of a blunt point on one side of the hack saw blade
Buy your self some new brushes and also clean the brush holders maybe replace the armature bearing or bushed
I used to use a thread tape screw it into the bush and once it bottoms out the tape will pull it out
Also I use to put the armature bush on one finger fill it with oil and then press down on the top of the bush with my thumb then the oil would squeeze out of the bush
That's a long time ago South Ace I'm a a dinosaur
The bendix drive will have two collets like a valve collet or a wire ring after drepping the spring remove the wire clip and then the bendix drive
This message will self destruct in 30 seconds
I feel it's more of a gear drive explosion rather than preventative maintance issue HO2
this is reconditioning your old starter
This is what Id do if I was pulling it apart then paint it and bolt it back on have a beer and never go back to that start for ten years plus
What's your post box I will just send it to you!
Ok send the new bedix drive as well please Ill PM you
Also what color do you prefer on the Starter Motor when its finished
Original! Bendex?
if you cant Ill find one in Vic
Ill have to see if willies got a growler to test the armature segments ,should have