I hate to just throw them away, but finding things to use them for is not so easy.
some of the things I've done over the years are:
patches for other old wettys that are still in reasonable nic
Pads on shaping or glassing stands
Pads on roof racks
Pads between boards on racks
A knee support when the arthritis plays up
Today I used an arm to make a few condoms for a spray gun pot.
I don't have this problem with a gravity pot, but the suction feed pot sometimes gets droplets of paint on the outside if I'm not paying attention. Then when I'm over the job, they drip onto the sprayed surface and I say lots of rude words.
I usually tape some rag around the pot, but I may try the condoms the next time to see if they help.
Has anyone else came up with any creative uses?
Tilt you heads, I still can't turn these pics
there was a pretty useless thread on the inertia - but a couple of good ideas. make a quick and easy camera/gopro bag that can get washed out. also water bottle holder etc
Use 'em for dash mats, liners in boxes where you want a soft bottom.... there was no good way to say that..... for when you don't want to have things rolling around in your box.....
Good for soaking up blood in the gimp room.... sound deadening too.
I also made a balaclava out of one, but it's a bit hard to breath through, so put that in the gimp room as well.
Use 'em for dash mats, liners in boxes where you want a soft bottom.... there was no good way to say that..... for when you don't want to have things rolling around in your box.....
Good for soaking up blood in the gimp room.... sound deadening too.
I also made a balaclava out of one, but it's a bit hard to breath through, so put that in the gimp room as well.
I hate to just throw them away, but finding things to use them for is not so easy.
some of the things I've done over the years are:
patches for other old wettys that are still in reasonable nic
Pads on shaping or glassing stands
Pads on roof racks
Pads between boards on racks
A knee support when the arthritis plays up
Today I used an arm to make a few condoms for a spray gun pot.
I don't have this problem with a gravity pot, but the suction feed pot sometimes gets droplets of paint on the outside if I'm not paying attention. Then when I'm over the job, they drip onto the sprayed surface and I say lots of rude words.
I usually tape some rag around the pot, but I may try the condoms the next time to see if they help.
Has anyone else came up with any creative uses?
Tilt you heads, I still can't turn these pics
hmmmmmmmmm bring that little sucker up to Woopi with you ..... I can see you in a sublimely magnificent Phantom mask come Saturday evening