Hi all,
See attached pics - is this fin safe to use as is?
This fin came with my 2010 IsonicW49 when I bought it two seasons ago, I have been using C3 Venoms 24 & 26 on the W49 but are curious how this carbon fin goes. It's a 26cm C3 Z fin (a Boogie carbon custom?), possibly a great fin but will only know if I can safely give it a try with confidence 
Fix it as it is easy. I drill a hole of about 4mm through base about a 1cm below where base meets bottom of fin. Then insert a brass slug - 4mm wide in hole as a proxy for a 'strengthening pin' which should be 0.5mm less long than base width. Then fill each side with a drop of epoxy. Sand flat. Looks good when dries as brass shines. 2min job excluding time for epoxy to dry.
Not tried on that particular fix. But Superglue n Bicarb Soda works a treat on fin edges etc.
Nup, that's a heavy stress fracture, probably caused by a lot of sideways load on the fin, it can't get a lot worse, because the finbox should stop it opening up any more. But just gluing the crack, won't be strong enough to resist the kind of loads that cracked it in the first place. The brass dowle also wont help with the sideways loads, but could stop a blow to the rear of the fin making it any worse. Personally I think I'd either ignore it. Or grind it out and replace with lots of fibre.
As an instructor, and as a guy who has had long swims from broken fins, I would say, toss it and get a new one. Don't chance it. Not worth it.
Select to expand quoteforceten said..
3rd option. Bin it.
Get another fin.
?agree. Had similar to OP's damage and sailed around happily for a few months thinking it's not going to give because it's all wedged in the fin box. It gave last week, fun trip back in dredging my harness. Replace imo
The actual fin extends down into the head and probably isn't cracked. The only way to find out is to grind off the head material and then get a new head cast on. Looks to me that the crack has started where the head material hasn't bonded to the fin properly. I have found this on a few fins I have re boxed when grinding the head down. When the head material gets thin you can get your finger nail under it and peel it off.
Agree, don't use until fixed.
Ask around, there may be someone local that can re box it for you.
Thanks everyone for their thoughts on this.
Got the message - I won't risk using it as it is!
Will look at fixing it after a grinding investigation, should be a good learning experience along the way !
Select to expand quotesegler said..
As an instructor, and as a guy who has had long swims from broken fins, I would say, toss it and get a new one. Don't chance it. Not worth it.
Depends on what you're doing. 2km runs out in the ocean- Totally agree.
